By American Water Works Association.; American National Standards Institute
Read or Download AWWA standard for cement-mortar protective lining and coating for steel water pipe : 4 in. and larger-- shop applied PDF
Best applied books
Booklet by way of Kreyszig, Erwin
The target of geometric numerical integration is the simulation of evolution equations owning geometric houses over lengthy instances. Of specific value are Hamiltonian partial differential equations generally coming up in software fields comparable to quantum mechanics or wave propagation phenomena.
- Applied Math Modeling - A Multidisciplinary Apprch
- Tietz's Applied Laboratory Medicine, Second Edition
- Fracture, Fatigue, Failure, and Damage Evolution, Volume 5: Proceedings of the 2014 Annual Conference on Experimental and Applied Mechanics
- Affinity Chromatography. Biospecific Sorption–The First Extensive Compendium on Affinity Chromatography as Applied to Biochemistry and Immunochemistry
- Applied Laser Tooling
- Applied Inverse Problems: Select Contributions from the First Annual Workshop on Inverse Problems
Extra resources for AWWA standard for cement-mortar protective lining and coating for steel water pipe : 4 in. and larger-- shop applied
Inspection by the purchaser or failure of the purchaser to provide inspection shall not relieve the constructor or the manufacturer of the responsibility to provide materials and to perform work in accordance with this standard. 4 Tests. Tests the purchaser makes on material samples shall be made without delay. If any sample fails to meet the requirements, the manufacturer shall be notified immediately. Material affected by the test results shall be set aside pending final disposition. 5 Notice of Nonconformance.
Material affected by the test results shall be set aside pending final disposition. 5 Notice of Nonconformance. Material and pipe that are discovered to be defective or that do not conform to the requirements of this standard may be repaired in accordance with the provisions of this standard. An effort shall be made by the purchaser to inspect the pipe in the manufacturer’s plant pursuant to Sec. 1. Nonconforming material and pipe shall be removed from the work site within a reasonable period of time.
The joint shall be filled with cement mortar by pouring from one side only until the cement mortar reaches at least the pipe spring line on the opposite side, and shall be rodded with a wire or other flexible rod, or vibrated so that the cement mortar completely fills the joint recess by moving down one side of the pipe, around the bottom of the pipe, and up the opposite side. Pouring and rodding the cement mortar shall be continued to allow completion of the filling of the entire joint recess in one operation.